UK inland waterways popularity surges according to the Annual Lockage Report

The Annual Lockage Report has been published by the Canal & River Trust
The Annual Lockage Report has been published by the Canal & River Trust

The Canal & River Trust says that waterways activity in 2021 surged in popularity post lockdown. The Canal & River Trust’s Annual Lockage Report for 2021 shows that as Covid-19 restrictions lifted in the spring, most places recorded counts that were close to pre-pandemic levels and a boom in lock use.

“The last two years have been like no other, with the lifting of pandemic restrictions resulting in increases in lock use that are unprecedented in the 21 years of preparing this report,” said Adam Comerford, national hydrology manager at the Canal & River Trust.

The Annual Lockage Report, now in its 21st year, shows how many times locks were used across the charity’s 2,000 miles of waterways compared to the Continue reading “UK inland waterways popularity surges according to the Annual Lockage Report”

Engine fault due to effect of low-sulphur fuel on injection control unit says report

Coking debris found in the cavity on the fuel oil side of the servo piston. Photo credit: TAIC
Coking debris found in the cavity on the fuel oil side of the servo piston due to low-sulphur fuel Photo credit: TAIC

A Transport Accident Investigation Commission (TAIC) report reveals that the Singapore-flagged ship Funing had been unable to generate full power because a fuel injector control unit (ICU) had suffered fuel leakage and become clogged with coking debris from the use of low-viscosity low-sulphur fuel.

On 5 July 2020, the log carrier Funing finished loading its cargo at the Port of Tauranga and began preparations for departure. At about 2200 the officer of the watch contacted the engineers and informed them that departure was planned for midnight. When the main engine was tested in the astern direction, the main engine fault log indicated there was a fuel injection quantity piston failure. The engineering team attempted to rectify the fault but were unable to before the vessel departed its berth at about 0018, when the fault reoccurred again Continue reading “Engine fault due to effect of low-sulphur fuel on injection control unit says report”

Public consultation of Australia’s Domestic Commercial Vessel Safety legislation open until 30 March 2022

The Independent Review of Australia’s Domestic Commercial Vessel Safety Legislation and associated Costs and Charging Arrangements has commenced. Information about the review, including terms of reference and reviewer information can be viewed here.

The review will be conducted in two phases, with the first to focus on the National Law framework (Phase 1) and the second to consider national system delivery costs and future funding options (Phase 2).

Submissions for Phase 1 of the review are now being sought and a Consultation Aid has been published. To make a submission, please go Continue reading “Public consultation of Australia’s Domestic Commercial Vessel Safety legislation open until 30 March 2022”

Annual Shipping Industry Flag State Performance Table published by the International Chamber of Shipping

Shipping Industry Flag State Performance Table 2021/2022 released by ICS
Shipping Industry Flag State Performance Table 2021/2022 released by ICS

The annual Shipping Industry Flag State Performance Table 2021/2022, from the International Chamber of Shipping, has identified reporting on seafarer wellbeing as a “casualty of the pandemic,” following its publication.

The Table is intended to encourage shipowners to maintain a dialogue with their Flag states, and help facilitate necessary improvements in the interests of safety, the environment and decent working conditions, among other issues. The Flag State of a merchant ship is the jurisdiction under whose laws the ship is registered or licensed and is deemed the nationality of the vessel.

This year’s Shipping Industry Flag State Performance Table highlights a drop in levels of reporting on the status of national ILO labour Continue reading “Annual Shipping Industry Flag State Performance Table published by the International Chamber of Shipping”

ABS Port State Control Quarterly Report Q4 2021

The focus of the American Bureau of Shipping (ABS) is to provide classification services to promote the common safety, environmental and regulatory interests of its members and clients, including builders, owners, operators and surveyors of ships. Since its inception in 1862, ABS has been a global leader in marine safety. With more than 2,000 technical professionals positioned around the world, the ABS team has the experience, knowledge, and professional judgment to assist vessel owners and operators.

The ABS Port State Control Quarterly Report (PSC) provides information with photos of deficiencies identified on ABS vessels during inspections carried out by the various PSC regimes globally during the 4th Quarter of 2021. This report is being made available to assist Continue reading “ABS Port State Control Quarterly Report Q4 2021”

Australian operators with fixed gas LPG systems must be aware of appliances listed on the installation compliance plate

The Australian Maritime Safety Authority (AMSA) has released details of an investigation into an incident where the owner and their son were seriously injured in an explosion in the galley of their houseboat due to the stove ignitor igniting a gas leak.

On 30 June 2021, a class 4E domestic commercial vessel houseboat used for recreational purposes was at anchor in the backchannel of a Northern NSW river. The owner and their son were onboard and the owner was preparing dinner in the galley at the starboard aft end of the main cabin.

The owner attempted to light a gas-powered stove by a piezo ignition switch when a blast explosion took place causing catastrophic Continue reading “Australian operators with fixed gas LPG systems must be aware of appliances listed on the installation compliance plate”

Using remote survey techniques to augment shipyard surveys being examined

A pioneering joint development project (JDP) between ABS and Nakilat – Keppel Offshore & Marine Ltd. (N-KOM) will examine how techniques developed by ABS for its industry-leading program of remote survey of vessels in service can be applied to surveys and inspections in the shipyard.

Remote inspection technologies will be applied to six Class surveys for this trial, to test how they can then be used to verify the required survey or inspection by ABS Surveyors to optimize scheduling and minimize downtime for both the shipyard, vessels and ABS.

The JDP will examine how remote techniques can be carried out on rudder clearance inspection; stern tube weardown inspection; rudder Continue reading “Using remote survey techniques to augment shipyard surveys being examined”

IIMS February News Bulletin published

The 26 page February News Bulletin from IIMS has been published and it’s been a busy news month, both for the Head Office team and with breaking news from around the industry affecting the surveying profession.

Download the News Bulletin for more information about the following topics and more:
– The advice is: keep batteries of any kind away from metal objects
– Important recently announced MCA amendments
– Getting to zero coalition – closing the gap: A new report
– BEIS releases five guidance documents on the UKCA mark in preparation for 1 January 2023 Continue reading “IIMS February News Bulletin published”

The purpose and limitations of silver nitrate testing

Silver nitrate testing should be seen only as a means of establishing the presence of chlorides
Silver nitrate testing should be seen only as a means of establishing the presence of chlorides. Image for illustrative purposes only.

Silver nitrate testing is carried out to detect the type of halide ion in a given solution. Steel products such as coils of rolled steel sheet, billets, tubes and steel plate are routinely presented for shipment at sea. The hot rolled steel products can at times be transported to outside shore storage and transit sheds without the provision of a covering or protection from the elements.

Steel products can be high value cargo that is susceptible to contamination from chlorides which are corrosive. Contamination from chlorides can occur at any stage of the transportation and storage process following production. Unfortunately, it is generally only during sea transportation that claims will be brought forward for alleged “seawater wetting” as it is an easy allegation that the contamination has Continue reading “The purpose and limitations of silver nitrate testing”

Corrosion of tank containers’ inner surface now the main cause of claims says TT Club

The main cause of claims is from corrosion of tank containers’ inner surface
The main cause of claims is from corrosion of tank containers’ inner surface

TT Club’s analysis of 2020 claims points to an increase in impact related incidents, with corrosion of tank containers’ inner surface and contamination caused by cargoes previously carried as significant other causes of loss.

The analysis makes clear that the effects of increased volumes of tank containers used to trade chemicals and other liquids on the primary east-west trades have altered, to a degree, the risk profile of damage to such units. While in previous years there has been a consistent dominance of contamination as the major source of losses for tank container operators, the current figures show impact incidents as the foremost causation. Continue reading “Corrosion of tank containers’ inner surface now the main cause of claims says TT Club”

AMSA requests feedback on proposed changes to air pollution regulations

AMSA has requested feedback on air pollution regulations
AMSA has requested feedback on air pollution regulations

AMSA requests online feedback on changes to Marine order 97 by 20 March 2022. This marine order, which deals with the prevention of air pollution from vessels and gives effect to MARPOL Annex VI, applies to regulated Australian vessels (RAVs), domestic commercial vessels (DCVs), recreational vessels, and foreign vessels and is expected to become effective in 2023.

The key proposed changes in the marine order are as follows:
– a diesel engine with a power output of more than 130 kW installed on an existing or new DCV will be required to have an engine Continue reading “AMSA requests feedback on proposed changes to air pollution regulations”

Major changes in the ABS Marine Vessel Rules announced from January 2022

The ABS 2022 Marine Vessel Rules have changed in January 2022, in some cases significantly
The ABS 2022 Marine Vessel Rules have changed in January 2022, in some cases significantly

In an open communication to the maritime industry, Adam W. Moilanen, Vice President/Chief Surveyor with the American Bureau of Shipping (ABS), has written to advise of the raft of major changes in the ABS 2022 Marine Vessel Rules, Material and Welding, High Speed Craft, Mobile Offshore Units (MOU), Facility on Offshore Installations (FAC) and Single Point Moorings (SPM) that became effective on 1 January 1 2022.

In brief, the changes to the ABS 2022 Marine Vessel Rules are: Continue reading “Major changes in the ABS Marine Vessel Rules announced from January 2022”

Instagram Posts from the IIMS @iimsmarine