UK P&I Club releases a detailed guidance report on packing dangerous goods for carriage by sea

UK P&I Club releases a detailed guidance report on packing dangerous goods for carriage by sea
UK P&I Club releases a detailed guidance report on packing dangerous goods for carriage by sea

As accidents involving dangerous goods continue to occur with regularity at sea, the UK P&I Club has published a comprehensive guide running to more than 100 pages to support operators who pack dangerous goods into cargo units for onward transportation by sea.

As part of the new guide, UK P&I Club makes the following points and advice:
– Improper packing practices and loads not properly secured increase the number of accidents across the supply chain and have as a result caused damages, loss and injuries, both on land and at sea.
– There is a lack of guidance regarding personnel working in the cargo handling industry. That is where the Code of Practice for Packing of Cargo Transport Units (CTU) becomes relevant. The CTU provides information regarding packing cargo in containers, in order to comply with the requirements of sea and land transport.
– Classification of dangerous goods: The first key task for an operator is to make sure that the dangerous goods on board have the correct UN classification.
– Selection of Continue reading “UK P&I Club releases a detailed guidance report on packing dangerous goods for carriage by sea”

Guidelines for ensuring the safe carriage of cocoa butter in freight containers

Guidelines for ensuring the safe carriage of cocoa butter in freight containers
Guidelines for ensuring the safe carriage of cocoa butter in freight containers

Members of the CINS Organisation (the Cargo Incident Notification System) have issued guidance and guidelines for the carriage of cocoa butter in freight containers, under the principles set out in the IMO/ILO/UNECE Code of Practice for Packing of Cargo Transport Units (CTU Code).

Nature of cocoa nutter cargo
Cocoa butter is derived from whole cocoa beans which are fermented, roasted, and then separated. About 54–58% of the residue is cocoa butter, containing 57-64% of saturated fats and 43-36% unsaturated fats. Cocoa butter becomes soft and malleable at 30-32°C and can melt at 37°C. Having become warm or molten, it can retain the latent heat and remain in such a condition down to as low as 17°C.

Upon heating, cocoa butter expands and may cause it to Continue reading “Guidelines for ensuring the safe carriage of cocoa butter in freight containers”

Sirena Yachts set to debut in the superyacht sector

Sirena Yachts set to debut in the superyacht sector
Sirena Yachts set to debut in the superyacht sector

Sirena Yachts chose the 2018 Miami Yacht Show to unveil further details of its 26-metre (85.3-foot) flagship Sirena 85, which marks its entrance into the superyacht sector. The Sierna 85 is Sirena Yachts’ flagship, marking its entrance to the superyacht market.

With construction already underway at the Turkish shipyard, she features exterior design by Frers Naval Architecture & Engineering, and interiors by Cor D Rover.

According to the yard, her lines are the evolution of the sleek styling that it has come to be known for, with a glass-fibre hull and carbon-fibre superstructure guaranteeing lightweight durability.

German Frers, naval architect and head of exterior design and engineering, said, Continue reading “Sirena Yachts set to debut in the superyacht sector”

New initiative and project on marine energy biofouling announced

New initiative and project on marine energy biofouling announced
New initiative and project on marine energy biofouling announced

The International Centre of Island Technology (ICIT) and the European Marine Energy Centre (EMEC) have joined forces in a year-long project to tackle biofouling in the marine renewable energy sector.

Under the auspices of the Biofouling in Renewable Energy Environments – Marine (BioFREE) project researchers will look at practical strategies to minimise the impacts of biofouling which can decrease the efficiency of energy generation and lead to corrosion of renewable technologies.

“The location of our campus in Orkney and our close working relationship with EMEC will provide Continue reading “New initiative and project on marine energy biofouling announced”

IIMS set to launch Marine Surveying International Fest 2018

Most professions and activities recognise their own special international days to create awareness. Three such examples are World Radio Day, World Puppetry Day and International Firefighters’ Day. IIMS thought it was high time that marine surveyors have their own day – a day that celebrates their work and profession and brings them together, albeit in an online capacity.

So, IIMS has created the Marine Surveying International Fest 2018, a 24-hour celebration of marine surveying. The date for this innovative and eye-catching event is Wednesday 12 into Thursday 13 September, depending on your time zone! View full press release.

New class notations aim to improve stern tube bearing performance

DNV GL has revised its class rules for single stern tube bearing installations and introduced two new class notations, “Shaft align(1)” and “Shaft align(2)”, to help customers better manage the risk of stern tube bearing failure. The new class notations can be assigned to both newbuilds and vessels in service in conjunction with propeller shaft withdrawal.

The classification rules covering shaft alignment are formulated to achieve an acceptable distribution of loading on the shaft bearings and lubrication of the aft bearing, taking into consideration the bending moment induced by the propeller during operation. However, during turning manoeuvers at higher ship speeds, exaggerated propeller bending moments can occur, potentially resulting in a reduced shaft- Continue reading “New class notations aim to improve stern tube bearing performance”

Operators and surveyors urged to test cargo hold’s bilge system to minimise claims

Operators and surveyors urged to test cargo hold bilge systems to minimise claims
Operators and surveyors urged to test cargo hold bilge systems to minimise claims

The UK P&I Club has reminded those working in the marine industry that significant insurance damage claims can result if a bulk cargo is damaged due to the leakage of the bilge system into a loaded bulk cargo hold.

To reduce the chance of such cargo damage, operators and surveyors are advised to inspect and test the cargo hold bilge system as part of the routine pre-loading checks of the cargo holds.

Inspection and testing of cargo hold bilge system non-return valves should be included in routine pre-loading checks of the holds. These non-return valves may not be seated tightly, because of the Continue reading “Operators and surveyors urged to test cargo hold’s bilge system to minimise claims”

Rolls-Royce to provide tug sector with its first Hybrid System

Photo credit: Rolls-Royce
Photo credit: Rolls-Royce

Rolls-Royce will supply the tug boat sector with its first hybrid propulsion arrangement for installation to a multi-purpose tractor tug undergoing construction for Baydelta Maritime LLC. The vessel is being built at Nichols Brothers Boat Builders, in Washington State, U.S.A.

The order represents the first hybrid tug using proven Rolls-Royce hybrid technology, the first installation of a hybrid system for Nichols Brothers and the first hybrid tug designed by Jensen Maritime, Crowley Maritime Corp’s Seattle-based naval architecture and engineering firm.

The 100-foot long tug will feature the same ship assist and tanker escort capabilities of existing Delta Class harbour tugs but with greatly improved towing performance. The Rolls-Royce hybrid system enhances the Continue reading “Rolls-Royce to provide tug sector with its first Hybrid System”

Revolutionary ultraviolet light-emitting diodes fouling prevention technology under development

Revolutionary ultraviolet light-emitting diodes fouling prevention technology under development
Revolutionary ultraviolet light-emitting diodes fouling prevention technology under development

AkzoNobel has teamed up with Netherlands based healthcare company Royal Philips to develop ultraviolet light-emitting diodes fouling prevention technology.

The system will use technology developed by Royal Philips with the aim of combining experience from both companies to produce an economically viable solution for underwater fouling prevention.

The system will integrate UV light-emitting diodes in a protective coating, which AkzoNobel says will allow for the UV light to be emitted from the coating surface, preventing biofouling from accumulating.

“In our sustainable fouling control initiative, we actively explore and develop alternatives to Continue reading “Revolutionary ultraviolet light-emitting diodes fouling prevention technology under development”

ILO adopts a new Code of Practice to improve safety and health in shipbuilding and ship repair

ILO adopts a new Code of Practice to improve safety and health in shipbuilding and ship repair
ILO adopts a new Code of Practice to improve safety and health in shipbuilding and ship repair

Representatives of governments and the social partners from around the world gathered at the ILO from 22 to 26 January 2018 to adopt a revised code of practice on safety and health in shipbuilding and ship repair.

The new code reflects the many changes in the industry, including the use of robotic systems, over the last 43 years since an earlier code was adopted by the ILO. It focuses on the need for a preventive approach based on occupational safety and health (OSH) management systems, management of change and safe work plans among others.

Participants emphasized the importance of improving occupational safety and health (OSH) in shipbuilding and ship repair. Improved OSH performance will reduce Continue reading “ILO adopts a new Code of Practice to improve safety and health in shipbuilding and ship repair”

Autonomous vessels – the challenges and opportunities in design

Autonomous vessels – the challenges and opportunities in design
Autonomous vessels – the challenges and opportunities in design

Automation presents a set of unique challenges to designers, insurers and operators of ships. In this article, reprinted from the Shipowners P&I Club website Keir Gravil, a naval architect at Frazer-Nash Consultancy in Bristol, UK discusses some of the key issues that could face automated ships of the future from a design perspective.

It is a truth recognised by many industries that the future of transportation lies with greater automation. Over the last 50 years we have seen huge changes not only in shipping, but in every form of transportation and vehicle. Aircraft now incorporate automation routinely on flights around the world, cars are being developed to drive themselves and many railways have been totally automated for some time. As each step in the evolution of transportation progresses, the human element of control is reduced or eliminated altogether. But what of shipping? Surely an industry the size and scope of international shipping faces unique challenges in the realm of automation?

The background
It is often the job of ship designers, especially those in the naval defence industry, to think ahead and anticipate future technological changes. One could argue that Continue reading “Autonomous vessels – the challenges and opportunities in design”

UK Transport Secretary proposes Maritime 2050 vision

UK Transport Secretary proposes Maritime 2050 vision
UK Transport Secretary proposes Maritime 2050 vision

Speaking at the UK Chamber of Shipping’s Annual Dinner, Chris Grayling MP, UK Secretary of State for Transport, contributed to a “radical” vision that will support the nation’s maritime industry for the future.

The UK Government will cooperate with industry bodies and businesses, and will publish a call for evidence that will provide a framework for engagement. An expert panel will also be appointed, Mr Grayling said.

“We need a clear path for the future, we need a strong partnership between this industry and government – and we’re calling it Continue reading “UK Transport Secretary proposes Maritime 2050 vision”

Instagram Posts from the IIMS @iimsmarine

Privacy Overview

This website uses cookies so that we can provide you with the best user experience possible. Cookie information is stored in your browser and performs functions such as recognising you when you return to our website and helping our team to understand which sections of the website you find most interesting and useful.

Strictly Necessary Cookies

Strictly Necessary Cookie should be enabled at all times so that we can save your preferences for cookie settings.

Show details
Performance & Marketing Cookies

This website uses Google Analytics to collect anonymous information such as the number of visitors to the site, and the most popular pages. This also helps us optimise our marketing campaigns. User data sent to Google Analytics may be used for ad personalization and measurement of our ad campaigns. Keeping this cookie enabled helps us to improve our website.

Show details